In recent years, the development of cadmium zinc telluride (CdZnTe) detectors for x-ray and gamma ray spectrometry has grown rapidly. The good room temperature performance and the high spatial resolution of pixellated CdZnTe detectors make them very attractive in space-borne x-rayastronomy, mainly as focal plane detectors for the new generation of hard x-ray focusing telescopes.In this work, we investigated on the spectroscopic performance of two pixellated CdZnTe detectors coupled with a custom low noise and low power readout application specific integrated circuit (ASIC). The detectors (10x10x1 and 10x10x2 mm3 single crystals) have an anode layoutbased on an array of 256 pixels with a geometric pitch of 0.5 mm. The ASIC, fabricated in 0.8 micron BiCMOS technology, is equipped with eight independent channels (preamplifier and shaper) andcharacterized by low power consumption (0.5 mW/channel) and low noise (150–500 electrons rms).The spectroscopic results point out the good energy resolution of both detectors at room temperature[5.8% full width at half maximum (FWHM) at 59.5 keV for the 1 mm thick detector; 5.5% FWHM at 59.5 keV for the 2 mm thick detector] and low tailing in the measured spectra, confirming the single charge carrier sensing properties of the CdZnTe detectors equipped with a pixellated anodelayout. Temperature measurements show optimum performance of the system (detector and electronics) at T=10 °C and performance degradation at lower temperatures. The detectors and the ASIC were developed by our collaboration as two small focal plane detector prototypes for hard x-ray multilayer telescopes operating in the 20–70 keV energy range.
|Numero di pagine||9|
|Rivista||Journal of Applied Physics|
|Stato di pubblicazione||Published - 2009|
All Science Journal Classification (ASJC) codes
- Physics and Astronomy(all)