FROM SFM TO 3D PRINT: AUTOMATED WORKFLOW ADDRESSED TO PRACTITIONER AIMED AT THE CONSERVATION AND RESTAURATION

Francesco Di Paola, Laura Inzerillo, Laura Inzerillo, Francesco Di Paola

Risultato della ricerca: Conference article

4 Citazioni (Scopus)

Abstract

In In the last years there has been an increasing use of digital techniques for conservation and restoration purposes. Among these, a very dominant rule is played by the use of digital photogrammetry packages (Agisoft Photoscan, 3D Zephir) which allow to obtain in few steps 3D textured models of real objects. Combined with digital documentation technologies digital fabrication technologies can be employed in a variety of ways to assist in heritage documentation, conservation and dissemination.This paper will give to practitioners an overview on the state of the art available technologies and a feasible workflow for optimizing point cloud and polygon mesh datasets for the purpose of fabrication using 3D printing. The goal is to give an important contribute to confer an automation aspect at the whole processing. We tried to individuate a workflow that should be applicable to several types of cases apart from small precautions. In our experimentation we used a DELTA WASP 2040 printer with PLA easyfil.
Lingua originaleEnglish
pagine (da-a)375-382
Numero di pagine8
RivistaINTERNATIONAL ARCHIVES OF THE PHOTOGRAMMETRY, REMOTE SENSING AND SPATIAL INFORMATION SCIENCES
Volume42
Stato di pubblicazionePublished - 2017

    Fingerprint

All Science Journal Classification (ASJC) codes

  • Information Systems
  • Geography, Planning and Development

Cita questo